1: After all your elements were removed from the mat, we are going to start assembling our card, we are going by adding our brown and dark green design and glue them:
2: We are going to gran our full cloud and glue them into the brown cardstock:
3: We are now going to proceed and do the same with the trees:
4: Lastly, we are going to glue the bushes:
5: We are going to grab the back of our card and one of the white sections with the small white circle:
We are going to glue them using the glue runner, making sure that we add the glue as close as possible to the corners and the outside and inside of the circles:
6: We are going to now generate our sunrise / sunset using inks, so we are going to grab one of our white cardstock and start applying the inks:
7: After we are done with our inks, we are going to proceed to glue our design:
8: Now we are going to proceed adding our gear
We are not adding any type of glue to our gear, we are only using the glue runner to glue our design (the back of it) to our white cardstock:
9: We are going to proceed by adding our center , and using the foam dots we are going to place them over our gear and glue the ghosts over the foam dots:
You can move the ghosts!!!!
💡Tip: If the foam dots are too big, you can cut them.
10: Our card is READY, you can add text or a sentiment on the back of your card if you like, once again… you did an amazing job!
In this tutorial, you are going to learn/practice the following functionalities:
- Slice Images/shapes
- Search Images
- Add Shapes and Images
- Resize Elements
- Add Text and Change Fonts
- Upload Fonts
- Delete Elements
- Attach Elements
- Change colors
- Weld Elements
- Print then cut