1: We are going to grab our wood sign and we are going to place the design over it before starting the transfer to make sure that everything looks as expected
💡Tip: You can use some tape to help you placing the design in the place that you want in order to be able to transferred without the design moving.
2: Now using your scraper, finger or even a ruler, you are going to rub over the vinyl, so the design is going to be transferred to the wood, after you did that all over the design, we are going to start peeling the transfer tape:
💡Tip: You need to peel the transfer tape very slowly, if the vinyl is not full adhere to the wood, you need to apply more pressure with the help of your scraper and try to peel it again.
💡Tip 2: After the peel if there is an air bubble you can use the scrapper or your finger to rub over it until is gone.
3: Once the design is fully transferred, you can use the ruler, scraper or your finger to make sure that the whole vinyl was fully transferred and that no air bubbles remain.
After this.. Your Wood sign is ready to place it in your favorite spot!