1: After the cut is done, you are going to unload the mat and we are going to remove the HTV from the mat very gently and you are going to weed all the excess related to each cut
2: We are going to turn on our Heat Press with the following settings:
Temperature: 300
Time: 30 seconds
💡Tip: Make sure to read the directions of the HTV that you are using, not all are the same and this also applies for removing the protective sheet some HTV are warming peeling, others are cooling.
3: We are going to start placing our design over the pillow cover, remember that in our case we need to apply it in phases, if you just did one cut with the whole design, you just need to apply it one time only.
4: You are going to repeat the process for all the different elements:
5: And after you added all the elements, you finished this amazing pillow!!!!
In this tutorial, you are going to learn/practice the following functionalities:
- Slice Images/shapes
- Search Images
- Add Shapes and Images
- Upload Images
- Resize Elements
- Delete Elements
- Attach Elements
- Change colors
- Weld Elements
